-- *********************************************************************
-- CISCO-PORT-TRACK-MIB.my: Cisco Port Track Mib
--
-- July 2004, Charuhas Ghatge
--
-- Copyright (c) 2004 by cisco Systems, Inc.
-- All rights reserved.
--
-- *********************************************************************-- Terminology-- Tracked-Port: It is a port whose operational state is
-- continuosly monitored. The operation state
-- (i.e. ifOperState) of the tracked-port is used to
-- alter the operational state of one or more ports.
--
-- Linked-Port: One or more ports are termed as
-- linked-ports, when the operational state of
-- these ports is altered based on the operational
-- state of the tracked-ports.
--
-- VSAN: Virtual Storage Area Network
--CISCO-PORT-TRACK-MIB DEFINITIONS::=BEGINIMPORTSMODULE-IDENTITY,OBJECT-TYPEFROM SNMPv2-SMI
MODULE-COMPLIANCE,OBJECT-GROUPFROM SNMPv2-CONF
TruthValue,RowStatusFROM SNMPv2-TC
InterfaceIndexFROM IF-MIB
ciscoMgmt FROM CISCO-SMI
VsanIndex FROM CISCO-ST-TC;ciscoPortTrackMIB MODULE-IDENTITYLAST-UPDATED"200504270000Z"ORGANIZATION"Cisco Systems Inc. "CONTACT-INFO" Cisco Systems
Customer Service
Postal: 170 W Tasman Drive
San Jose, CA 95134
USA
Tel: +1 800 553 -NETS
E-mail: cs-san@cisco.com"DESCRIPTION"A MIB to configure the Port-Track feature.
When a link goes down, all the services which depend
on the link are notified of the outage. The loss of
this link may be an indirect failure to the end devices
attached to the switch. The concept behind the Port-Track
feature is to create a direct failure on the ports
connected to end devices on event of such indirect
failures.
One more ports can be 'tracked' in terms of their
operational status. The cptPortTrackTable lets the user
associate which port(s) need to be tracked to the ports
that will be tracking them.
cptPortForceShutTable, lets the user configure the
forced-shut mode of the linked-port."REVISION"200504270000Z"DESCRIPTION"Initial version of this MIB module."::={ ciscoMgmt 437}
ciscoPortTrackObjects OBJECTIDENTIFIER::={ ciscoPortTrackMIB 1}cptMIBConformance OBJECTIDENTIFIER::={ ciscoPortTrackMIB 2}cptConfig OBJECTIDENTIFIER::={ ciscoPortTrackObjects 1}--
-- cptPortTrackTable
--cptPortTrackTable OBJECT-TYPESYNTAXSEQUENCEOF CptPortTrackEntry
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"A table listing the linked ports and the configurations
of their associated tracked ports. The configuration of
each tracked port includes its interface index as well
as a VSAN index if only one VSAN is to be tracked."::={ cptConfig 1}cptPortTrackEntry OBJECT-TYPESYNTAX CptPortTrackEntry
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"An entry in the cptPortTrack Table."INDEX{cptPortTrackLinkedPort,cptPortTrackTrackedPort}
::={ cptPortTrackTable 1}
CptPortTrackEntry ::=SEQUENCE{
cptPortTrackLinkedPort InterfaceIndex,
cptPortTrackTrackedPort InterfaceIndex,
cptPortTrackVsanType INTEGER,
cptPortTrackVsanIndex VsanIndex,
cptPortTrackRowStatus RowStatus}cptPortTrackLinkedPort OBJECT-TYPESYNTAXInterfaceIndexMAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"The ifIndex of the port that will be tracking the
cptPortTrackTrackedPort."::={ cptPortTrackEntry 1}cptPortTrackTrackedPort OBJECT-TYPESYNTAXInterfaceIndexMAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"The ifIndex of the port that needs to be tracked."::={ cptPortTrackEntry 2}cptPortTrackVsanType OBJECT-TYPESYNTAXINTEGER{singleVsan(1),
allVsans(2)}MAX-ACCESSread-createSTATUScurrentDESCRIPTION"This objects denotes whether a single VSAN is
being tracked on cptPortTrackTrackedPort or
all the VSANs on that port are tracked.
If the set to 'singleVsan', then the VSAN
that will be tracked will be denoted by the
instance of cptPortTrackVsanIndex."::={ cptPortTrackEntry 3}cptPortTrackVsanIndex OBJECT-TYPESYNTAX VsanIndex
MAX-ACCESSread-createSTATUScurrentDESCRIPTION"Valid only if the instance of cptPortTrackVsanType
is 'singleVsan'. If cptPortTrackVsanType is
'allVsans', the instance of this object is
irrelevant. "::={ cptPortTrackEntry 4}cptPortTrackRowStatus OBJECT-TYPESYNTAXRowStatusMAX-ACCESSread-createSTATUScurrentDESCRIPTION"This object is used to create or delete the row.
When creating a row, the object cptPortTrackVsanType
must be specified. If the value of
cptPortTrackVsanType is 'singleVsan' then the
object cptPortTrackVsanIndex also must be
specified. If the value of cptPortTrackVsanType
is 'allVsans', then cptPortTrackVsanIndex should
not be specified in the create request."::={ cptPortTrackEntry 5}--
-- cptPortForceShutTable
--cptPortForceShutTable OBJECT-TYPESYNTAXSEQUENCEOF CptPortForceShutEntry
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"A table to configure the forced-shut state
for each linked port."::={ cptConfig 2}cptPortForceShutEntry OBJECT-TYPESYNTAX CptPortForceShutEntry
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"An entry in the cptPortForceShutTable."INDEX{ cptPortTrackLinkedPort }::={ cptPortForceShutTable 1}
CptPortForceShutEntry ::=SEQUENCE{
cptPortForceState TruthValue}cptPortForceState OBJECT-TYPESYNTAXTruthValueMAX-ACCESSread-writeSTATUScurrentDESCRIPTION"The forced-shut state of the linked port.
When all the tracked ports corresponding to
cptPortTrackLinkedPort, go down, cptPortTrackLinkedPort
is brought down. The cptPortForceState, determines
the manner in which this operation is performed.
If 'false', cptPortTrackLinkedPort is brought down
operationally only and is brought up again as
soon as any one of the tracked ports comes up.
If 'true', cptPortTrackLinkedPort is brought down
administratively as well and the user has to
manually bring the port up. i.e. the ifAdminStatus
cptPortTrackLinkedPort needs to be set to 'up'
by the user."DEFVAL{ false }::={ cptPortForceShutEntry 1}-- conformance informationcptMIBCompliances OBJECTIDENTIFIER::={ cptMIBConformance 1}cptMIBGroups OBJECTIDENTIFIER::={ cptMIBConformance 2}cptMIBCompliance MODULE-COMPLIANCESTATUScurrentDESCRIPTION"The compliance statement for entities which
implement the portrack management mib."MODULEMANDATORY-GROUPS{ cptTrackGroup,
cptShutGroup }
::={ cptMIBCompliances 1}-- Units of ConformancecptTrackGroup OBJECT-GROUPOBJECTS{ cptPortTrackVsanType,
cptPortTrackVsanIndex,
cptPortTrackRowStatus
}STATUScurrentDESCRIPTION"Object group for the porttrack feature."::={ cptMIBGroups 1}cptShutGroup OBJECT-GROUPOBJECTS{ cptPortForceState }STATUScurrentDESCRIPTION"Object group for the forced-shut feature."::={ cptMIBGroups 2}END